LiquidityScan

· ICT CONCEPTS · 12 MIN READ · UPDATED 1D AGO

How to Trade EUR/USD With ICT Concepts: Bias, Sessions and the Sweep-Shift-Retrace Entry

How to Trade EUR/USD With ICT Concepts: Bias, Sessions and the Sweep-Shift-Retrace Entry

EUR/USD is the main forex pair, and its day follows a rhythm ICT traders can plan around: Asia builds a range, London raids it, New York continues or reverses. Here is the full process, from daily bias to entry, with the points where it fails.

The short answer

To trade EUR/USD with ICT concepts, you set a daily bias from the higher timeframe and mark the liquidity resting above and below price (the Asian range, the previous day's high and low). Then you wait for the London or New York kill zone to sweep one of those levels. If price reverses with displacement and shifts structure, the entry is on the pullback into a fair value gap or order block. The stop goes beyond the sweep and the target is the opposite pool of liquidity. No sweep, or no shift, means no trade.

Each step below is described for EUR/USD specifically, including the conditions under which the idea is wrong.

Why EUR/USD is the pair most ICT traders start with

EUR/USD is the main pair of the forex market. It is the most heavily traded, and it usually carries the tightest spread a broker offers. That matters for ICT-style entries because the stop sits just beyond a swept high or low, and a wide spread eats into that distance.

Its day also has a readable rhythm. The euro's home hours are the London session and the dollar's are New York. Stops build up during the quiet hours and get taken during the busy ones, which is the behaviour ICT concepts (from Michael J. Huddleston, the Inner Circle Trader) are built to describe.

A third advantage is that the euro is the largest component of the US dollar index (DXY), so EUR/USD and DXY tend to move as mirror images. That gives you a second chart to check your read against.

The limit is that EUR/USD can be slow. It can sit inside a range for days. ICT concepts tell you where liquidity rests and how price reacts when it gets there. They do not produce a move on a day when nothing is pushing the pair.

Step 1: Set the daily bias and the draw on liquidity

Bias is the direction you expect today's daily candle to expand. A simple mechanical read uses the last two daily candles:

  • Yesterday closed above the high of the day before: the bias is up.
  • Yesterday closed below the low of the day before: the bias is down.
  • Yesterday closed inside the prior day's range: there is no clean read, and that is useful to know before you risk anything.

The same rule can be checked across many markets at once, as described in the guide to an ICT daily bias scanner.

Bias needs a destination. The draw on liquidity is the level price is most likely reaching for, which in practice means a cluster of stop orders. Buy-side liquidity sits above old highs, where short sellers keep their stops. Sell-side liquidity sits below old lows. On EUR/USD the nearest obvious pools are the previous day's high and low, the previous week's high and low, and any equal highs or equal lows on the 4-hour chart.

A bullish bias with an untouched previous-day high overhead gives you a day for longs only. A bullish bias with no clear target above is a much weaker idea.

Step 2: Mark the levels before London opens

Draw these before the session, so you are not deciding what matters while price is moving:

  • Asian range high and low. This is the first liquidity London can reach. The method and its logic are covered in how to mark the ICT Asian range.
  • Previous day's high and low. These are the next pools out and are often the day's real target.
  • Previous week's high and low. They matter on days when price is already near them.
  • Unfilled zones on the 1-hour and 4-hour charts in the direction of your bias. A fair value gap (FVG) is a three-candle pattern where the wicks of the first and third candles do not overlap, so a gap is left in the middle. An order block is the last opposite-coloured candle before a strong move. If the first term is new to you, start with what a fair value gap is.

Step 3: Know which session does what

A kill zone is a time window when one financial centre is active and both stop runs and real moves tend to cluster. The windows below are the commonly used ICT ones in New York time. The full breakdown is in the guide to ICT kill zones for forex.

Window (New York time)What the ICT model expects from EUR/USDYour job
Asia, 20:00–00:00Europe and the US are offline, so the pair usually builds a narrow rangeMark the high and low. Do not trade the middle
London, 02:00–05:00First real volume of the day. One side of the Asian range gets raided, and the day's high or low is expected to form hereWait for a sweep and a shift in the direction of your bias
New York, 07:00–10:00US data lands at 08:30 on release days. Price either continues London's move or reverses itLook for a retrace into London's FVG or order block, or for a second sweep
London close, 10:00–12:00European desks square positions, and part of the day's move is often given backManage or close open trades. New entries here need a strong reason

Step 4: The entry: sweep, shift, retrace

Take a day with a bullish bias and the previous day's high untouched above. Asia has printed a narrow range. Shortly after London opens, EUR/USD drops through the Asian low, and perhaps through the previous day's low just beneath it.

That drop is the liquidity sweep, a move beyond an obvious level that triggers the stops resting there. On its own it tells you nothing yet. A sweep and the first leg of a real breakdown look identical while they are happening.

The next few candles on the 5-minute or 15-minute chart separate the two:

  1. Close back inside. Price closes back above the swept low instead of holding beneath it.
  2. Displacement. One or more large-bodied candles drive upward, clearly faster than the drift that came before.
  3. Shift. The push closes above the most recent lower high. That is a market structure shift (MSS), and it is covered in how to spot an MSS on major pairs. An earlier version of the same message is a change in state of delivery (CISD), a close above the open of the run of down candles that made the low.
  4. Retrace. The displacement leaves an FVG. Beneath it sits the last down candle before the push, which is the bullish order block. The entry ICT traders look for is price trading back into that gap or block.

Stop: below the low of the sweep. If that low breaks, the reason for the trade is gone.

Targets: the Asian high first, then the previous day's high that defined the draw. If the first target is closer than the stop, the pattern is there but the trade is not worth taking.

Invalidation: a candle that closes below the sweep low means it was a breakout and not a raid. A close straight through the whole FVG without a reaction means nobody defended the displacement.

The bearish version is the mirror image: a bearish bias, a raid above the Asian high, a shift down and an entry on the retrace up into a bearish FVG.

New York: continuation or reversal

By 07:00 New York time, London has usually shown its direction. There are two scripts to choose between.

Continuation. London made the low of the day and pushed up, but has not yet reached the draw. New York pulls back into the FVG or order block London left behind, holds it and carries on toward the previous day's high. This is the same entry logic as London, one leg later.

Reversal. London already reached the higher-timeframe draw. With that liquidity taken, price has nothing obvious left to reach for in that direction. A sweep of London's high followed by a bearish shift on the lower timeframe is then the pattern to watch.

On US release days, the 08:30 candle is fast in both directions and spreads widen. Many ICT traders let that candle close and treat its spike as the sweep, so they are not positioned through it. The reasoning is laid out in ICT news trading around high-impact events.

Cross-check with DXY and GBP/USD

EUR/USD and GBP/USD are both quoted against the dollar and usually make their swing highs and lows together. Sometimes EUR/USD sweeps its Asian low while GBP/USD holds above its own.

That disagreement is SMT divergence, where correlated markets fail to confirm each other's new high or low. It adds weight to the idea that the sweep was a raid. The article on reading EUR/USD against GBP/USD for SMT divergence goes through the cases.

DXY works the same way, inverted. If EUR/USD makes a lower low, DXY should make a higher high. When it does not, the new low on the euro is suspect. Neither check is a trigger. Both are extra evidence for a sweep you have already seen at a level you marked in advance.

Where this goes wrong on EUR/USD

  • No sweep. An FVG in the middle of the day's range, with no liquidity taken first, is only a gap. The sweep is what gives the zone a reason to hold.
  • Asia did not range. If EUR/USD trended through the Asian hours, there is no tight pool of stops for London to raid. The setup described here does not exist that day.
  • The sweep was a breakout. Price closes beyond the level and stays there. The distinction is covered in liquidity sweep vs breakout.
  • Fighting the bias. A clean bearish shift on the 5-minute chart against a bullish daily bias is usually a retracement. Treating it as a reversal is the common mistake.
  • Central bank and jobs-data days. Ahead of ECB and Fed decisions or US employment numbers, the pair tends to compress. Afterward it can run through several levels in one candle.
  • Stops too tight. Intraday swings on EUR/USD can be small. A stop a pip or two beyond the sweep can be taken out by spread widening alone at the session open.

The model also does not tell you how far price will travel. The draw on liquidity is a target, and price can stall short of it.

How to find EUR/USD setups on LiquidityScan

LiquidityScan is a web platform that scans markets for ICT and Smart Money Concepts patterns on closed candles. It is software and education. It is not a broker or a signal service, and it never tells you to buy or sell. Forex mode covers 72 instruments, EUR/USD is one of the seven majors, and all 15 scanners run on forex.

Start at the All Scanners page in Forex mode. Pages inside the app need a free account. The page shows all 15 scanners with live counts, and each card explains how its pattern works. Several scanners map directly onto the process above:

  • Bias uses the rule from Step 1: the previous close breaks beyond the candle before it. It is one of the eight classic scanners, which are free to read on 1H, 4H, 1D, 1W and 1M.
  • CRT and CISD, also classic, cover the sweep-and-close-back-inside and the change in state of delivery from Step 4.
  • Liquidity Sweep, Asia Range Sweep, Order Blocks and Fair Value Gaps are premium scanners. On the Free plan you see their live count but not the setups. Starter opens all 15 to browse, and alerts on the premium scanners begin on Base.
  • 5m and 15m exist only on the Fair Value Gaps and CISD+ scanners, on the Base plan and above. Every other scanner starts at 1H. The platform therefore covers the higher-timeframe context and the 1-hour read, and the lower-timeframe trigger for most patterns stays on your own chart.

You can star EUR/USD on any scanner page to follow its signals in your Watchlist. Detection waits for the candle to close, so a 1-hour pattern appears after the hour ends and not in the middle of a wick. A detection is context for your own decision.

Frequently Asked Questions

What is the best time to trade EUR/USD with ICT concepts?

The London kill zone (02:00–05:00 New York time) and the New York kill zone (07:00–10:00) are the two windows the ICT model is built around. London is where the Asian range typically gets raided. New York either extends that move or reverses it. Outside those hours EUR/USD often does too little to justify a stop-and-target structure.

What timeframes should I use for EUR/USD?

A common stack is the daily chart for bias and the draw on liquidity, the 1-hour or 4-hour chart for the zones you expect price to react from, and the 5-minute or 15-minute chart for the sweep, shift and entry. The lower timeframe only makes sense once the two above it agree.

Do I need to watch DXY to trade EUR/USD?

You do not need to, but it helps. The euro is the largest component of the dollar index, so the two charts normally mirror each other. When EUR/USD makes a new low and DXY fails to make a new high, that disagreement is worth noting before you trust the break.

Can I trade EUR/USD during the Asian session?

You can, but neither currency's home market is open, so the pair usually ranges. In the ICT framework those hours are for marking the range high and low that London will later target. Pairs involving the yen or the Australian dollar are more active at that time.

Does the London sweep of the Asian range happen every day?

No. Some days Asia trends and leaves no range. Some days London breaks out and never returns. On others the pair stays flat ahead of a news event. The setup needs a clear range, a sweep and a shift, and a missing piece means there is nothing to trade.

Is EUR/USD a good pair for learning ICT?

It is a reasonable first pair. Spreads are usually tight, the session rhythm is clear, and it moves less violently than pairs like GBP/JPY. The cost is patience, because EUR/USD has many days when the correct result of your analysis is no trade.

Hayk Muradian

Hayk Muradian

Founder & Lead Analyst at LiquidityScan · 12+ years ICT/SMC trading · Institutional order flow specialist

Hayk Muradian is the founder of LiquidityScan, a professional trading intelligence platform built for ICT (Inner Circle Trader) and Smart Money Concepts (SMC) traders. With over a decade of hands-on experience reading institutional order flow across crypto, forex, and futures markets, Hayk specializes in identifying liquidity events, order blocks, and CISD setups on closed candles.

He built LiquidityScan after years of frustration with retail charting tools that ignored the mechanics institutions actually use. The platform now scans 400+ markets in real-time, surfacing the same patterns floor traders watch — without the noise.

Hayk writes about the methodology behind ICT and SMC, with a focus on practical, data-driven analysis rather than hype. He is a vocal critic of "smart money" content that misrepresents institutional intent and a strong advocate for methodology-respectful education.

View all 386 articles by Hayk Muradian →

Not trading advice. LiquidityScan publishes educational content for informational purposes only. Trading involves substantial risk of loss.